Very simple first attempt at a custom cut, using Easel for the first time I was very easily and quickly able to come up with the design below.
I installed the Easel drivers for the computer and set up the tooling with parameters from the provide bit.
Sent it to the CNC and started the cut with good results!
After CNCing out the design earlier it was now time to finish, starting from this point: Using the table saw…
I bought a dust collection boot from FoxAlien but before I could use it I needed to create an adapter…
Starting from unfinished 5/4″ cedar I first planed the board down to ~7/8″: They were cut into block ~8″ wide…