Bought an Einstar 3D scanner a few months ago and haven’t really used it for a project yet. Decided to try to digitize the inside of the boat. This will probably be the first of a few posts to document the project not quite sure what the outcome will be yet but it’s good practice for the scanner and 3D modeling.
Replaced a few switches that were very sticky… Also replaced the cabin door lock with a new white one. Wasn’t…
After taking a shower I noticed that the water pump was running more often than it should. Only when the…
Noticed the starboard side trim cylinders were leaking at the end of last season. Ordered and replaced them before putting…